Filter
Top Products
Operatingprocedures
5. If necessary, press the Pause button once to put the printer in the READY state (Pause indicator OFF). If Pause remains
ON or other errors are displayed, refer to the following tables and the Troubleshooting section in this manual to
correct any errors before proceeding.
CAUTION If you enter one or more item IDs when the printer is not in the READY state, tags will immediately
begin to print, without stopping, when the printer is put back into the READY state.
6. Scan or otherwise enter barcode information as described in the online Staff Help (click the “?” button). The printer will
print item ID and library information on a blank RFID tag.
7. When printing is finished, the printer will separate the tag from the backing strip and present the tag at the printer front
opening. When you remove the tag, the printer is ready to print the next tag.
Control panel indicators — high volume printer
Control Panel Indicators Status
Indication
Off The printer is off or power is not applied.
POWER
On
The printer is on.
Off Normal operation.
TAKE LABEL
Flashing (Peel-off mode only) The tag is available.
Printing pauses until the tag is removed.
Off Normal operation — no printer errors.
ERROR
On
A printer error exists. Check the LCD for
more information.
Off Normal operation — ribbon is properly
loaded.
CHECK RIBBON
On
Printing is paused, the LCD displays a
warning message, and the PAUSE light is
on. No ribbon is loaded.
Off Normal operation — tag roll is properly
loaded.
PAPER OUT
On
No tag under the media sensor. Printing is
paused, the LCD shows an error message,
and the PAUSE light is on.
Off Normal operation.
PAUSE
On
The printer stopped all printing operations.
Causes include:
• PAUSE was pressed.
• A tag format included a pause
command.
• The online verifier detected an error.
• A printer error was detected.
The LCD gives additional information.
12
Copyright © 2009, 3M. All rights reserved.