Filter
Top Products
Maintenance
Cleaning — general
Periodically clean the exposed surfaces of Model 813 components as follows:
Note: Always TURN OFF system components before cleaning.
• DO NOT use any abrasive cleaners on the RFID pad. Gently rub the pad with a soft cloth dampened with a mild
cleaning solution.
• DO NOT use any liquid cleaning solutions on the RFID reader.
• Use care when cleaning the monitor. Use pre-moistened towelettes that are sold specifically for monitor cleaning. If these
are not available, use a non-solvent based cleaner to dampen a soft cloth and use it very sparingly.
• Clean the barcode scanner window regularly to minimize scanning problems. Wipe the scanner window with a clean,
dry, cotton-tip swab or cotton cloth.
Note: Per Code of Federal Regulations (CFR) 21CFR1040.10 for products containing lasers: CAUTION! Use of
controls or adjustments or performance of procedures other than those specified herein may result in hazardous
laser light exposure.
• To clean component exteriors, dampen a soft cloth with water or a mild cleaning solution and gently wipe away dirt.
Cleaning — print mechanism
Both printers offered by 3M for use with the Model 813 require “as needed” and “periodic” cleaning of print mechanism
components. 3M recommends that the library appoints one or two individuals to be responsible for printer cleaning schedules
and procedures. Those individuals should become familiar with applicable information in the manufacturer’s user guide that
applies to the printer included with your system. Both user guides can be found in PDF format on the 3M RF Tag Printer
Drivers CD-ROM.
• Model 813H high volume printer — Zebra 110 XiIII Plus User Guide
• Model 813R regular volume printer — Zebra TLP 2844-Z User Guide
Lubrication
No Model 813 components, including the 3M-supplied printer, require lubrication.
Copyright © 2009, 3M. All rights reserved.
35