Filter
Top Products
-
52 -
Rotate
Command to rotate to connect to the next network inside credentials.
Disconnect
Stop WPS action and disconnect this active link. And then select the last
profile at the Profile Page. If there is an empty profile page, the driver will
select any non-security AP.
Export Profile
Export all credentials to Profile.
Delete
Delete an existing credential. And then select the next credential if exist. If
there is an empty credential, the driver will select any non-security AP.
PIN
Registrar: Add the AP’s PIN code into the PIN code column, and press the
device PIN button. It will connect with the AP in two minutes and get IP
address.
Enrollee: Input the device’s PIN code into the PIN code column of AP. Start
AP WPS process and click device PIN button. Then, the device will connect
to AP in two minutes and get IP address.
PBC
Start to add to AP using PBC (Push Button Configuration) method. Click this
button to connect the AP which supported WPS function within two minutes.
Meanwhile, the AP should also click the PBC button simultaneously.
Note:
After the users click PIN or PBC, please do not rescan within two minutes of the
connection. If users want to stop this setup within the interval, restart PIN/PBC or
click "Disconnect" to stop WPS action.
WPS Associate IE
Send the association request with WPS IE during WPS setup. It is optional
for STA.
WPS Probe IE
Send the probe request with WPS IE during WPS setup. It is optional for
STA.
Progress Bar
Display rate of progress from Start to Connected status.
Status Bar
Display currently WPS Status.