Filter
Top Products
Command Line Interface
4-10
4
line
This command identifies a specific line for configuration, and to process subsequent
line configuration commands.
Syntax
line {console | vty}
• console - Console terminal line.
• vty - Virtual terminal for remote console access (i.e., Telnet).
Default Setting
There is no default line.
Command Mode
Global Configuration
Command Usage
Telnet is considered a virtual terminal connection and will be shown as “VTY”
in screen displays such as show users. However, the serial communication
parameters (e.g., databits) do not affect Telnet connections.
Example
To enter console line mode, enter the following command:
Related Commands
show line (4-18)
show users (4-61)
parity
*
Defines the generation of a parity bit LC 4-16
speed
*
Sets the terminal baud rate LC 4-16
stopbits
*
Sets the number of the stop bits transmitted per byte LC 4-17
disconnect Terminates a line connection PE 4-17
show line Displays a terminal line's parameters NE, PE 4-18
* These commands only apply to the serial port.
Console(config)#line console
Console(config-line)#
Table 4-5 Line Commands (Continued)
Command Function Mode Page