Filter
Top Products
Chapter 3 71
NOTE: 1.Because the CD-ROM module and the heat plate share the common screw, you only have to
remove the two screws as shown below If you detach the heat plate from the main unit after the step of
removing the CD-ROM. The same principle applies to the assembly procedures.
NOTE: 2.Please follow the numeric orders such as 1, 2, 3, and 4 to screw the heat plate to the main unit. It is
suggested that you reverse the sequence when you remove the screws.
Removing the LCD Module
1. See “Removing the Battery” on page 62
2. See “Removing the Middle Cover” on page 68
3. See “Removing the Keyboard” on page 69
4. See “Removing the Heat Plate” on page 70
5. Remove the two screws from the base of the unit.
6. Disconnect the LCD coaxial cable from the main board.