Filter
Top Products
82
Chapter 3: Replacing notebook components
Replacing the power button board
Tools you need to complete this task:
v
Screws removed during this task:
To replace the status indicator board:
1 Complete the steps in “Preparing the notebook” on page 55.
2 Remove the keyboard cover by following the steps in “Replacing the keyboard
cover” on page 78.
3 Open the keyboard compartment by following the steps in “Replacing the
keyboard” on page 80.
Important: You do not need to disconnect the keyboard cable from the
system board to complete this procedure.
4 Swing the black connector clip upward, then lift the cable out of the connector. Be
careful not to touch or damage any other components.
Flat-blade driver Scribe or non-marring tool- OR -
Phillips #0 screwdriver
2 black M2.5×5
(Keyboard cover)
3 black M2.5×4 (Power
button board)
Clip