Filter
Top Products
Chapter 1
Getting Started
18
Pointing Device Error Reconnect or replace the pointing
device.
Pointing Device Interface Error Check the pointing device interface
circuit.
Pointing Device IRQ Conflict Enter Setup and change the IRQ setting
of the PS/2 mouse.
IDE Drive 0 Error
IDE Drive 1 Error
IDE Drive 2 Error
IDE Drive 3 Error
Replace the disk drive or the HDD
(hard disk drive) controller. Check the
HDD cable connections and IDE
settings in Setup.
IDE Drive 0 / 1 / 2 / 3 Auto
Detection Failed
Replace the disk drive or the hard disk
drive controller. Check the HDD cable
connections and IDE settings in Setup.
Floppy Drive A Error
Floppy Drive B Error
Check if there is no floppy disk in the
drive. If there is, turn off the system
and check the cable connections. If the
connections are okay and the error
message continues to show, replace
the floppy drive.
Floppy Disk Controller Error Check the floppy drive cable and its
connections. If the cable is good and
properly connected, the floppy disk
controller may be the problem.
Change the floppy disk controller or
disable the onboard controller by
installing another add-on card with a
controller.
CPU Clock Mismatch When the user changes the CPU
frequency, this message will be shown
once. Then the BIOS will adjust the
CPU clock automatically.
Serial Port Conflict Change the onboard serial port
address in Setup or change the add-on
card serial port address.
Error Message Corrective Action
V76MSE.book Page 18 Wednesday, May 19, 1999 1:25 PM