Filter
Top Products
661 Brea Canyon Rd., Suite 3
Walnut, CA 91789
tel: 909.598.7388, fax: 909.598.0218
© Copyright 2009 Acnodes, Inc.
All rights reserved. Product description and product specifications
are subject to change without notice. For latest product information,
please visit Acnodes’ web site at www.acnodes.com.
RMC 7182
1U Rackmount System
SMBus to PCI Slots
Jumpers JI2C1 and JI2C2 allow you to connect the
System Management Bus (I2C) to the PCI slot. The
default set- ting is Open (Disabled.) Both jumpers
must be set to the same setting (JI2C1 controls the
clock and JI2C2 controls the data). See the table on
the right for jumper settings.
BMC Enable/Disable
The JBMC1 jumper allows the user to enable or
disable the BMC (Base- board Management Con-
trol) chip and the onboard IPMI connections. This
jumper is to be used together with the IPMI settings
in the BIOS. If this jumper is set to enabled, please
also enable IPMI in the BIOS and vice versa. The
default position is on pins 1 and 2 to enable BMC.
See the table on the right for jumper settings.
SAS Enable/Disable
JPS1 allows you to enable or disable the SAS
controller. The default posi- tion is on pins 1 and 2
to enable SAS. See the table on the right for jumper
settings.
SAS RAID Mode Select
JPS2 allows you to select the SAS RAID mode,
either Software RAID or IT Mode. Close this jumper
to use Software RAID (the default setting). Set this
jumper to open to use the IT Mode.