Filter
Top Products
25
&F Load Factory Settings
This command loads the configuration stored and programmed at the factory. This
operation replaces all of the command options and the S-register settings in the
active configuration with factory values.
&F: Recall factory setting as active configuration. (default)
&Gn V.22bis Guard Tone Control
This command determines which guard tone, if any, to transmit while transmitting
in the high band (answer mode). This command is only used in V.22 and V.22bis
mode.
&G0: Guard tone disabled (default).
&G1: Sets guard tone to 550 Hz.
&G2: Sets guard tone to 1800 Hz.
&Kn Serial Port Flow Control Selection
&K0: Disable flow control.
&K3: Enable RTS/CTS flow control (default).
&K4: Enable XON/XOFF flow control.
&Mn Asynchronous Communications Mode
&M0: Modem only supports asynchronous mode.(default)
&Pn Pulse Dial Make-to-Break Ratio Selection
This Command sets pulse-dial make-break ratio.
&P0 39%/61% make/break ratio, 10PPS
&PI 33%/67% make/break ratio, 10PPS (default)
&Qn Asynchronous Communications Mode
&Q0: Modem only supports asynchronous mode.
&Sn Data Set Ready (DSR) Option
This command selects DSR action.
&S0: DSR always ON (default).