Filter
Top Products
4-5
Installing ATM Version 4.0x Software for Windows NT
8
Enter Bus Type and Number from the dialog box and select
OK.
9
Select Close from the Network Control Panel window.
10
If IPX/SPX is installed on your workstation, the NWLink IPX/
SPX Protocol Configuration dialog box appears. If IPX/SPX is
not installed, this dialog will not appear.
■
Select the adapter that will support the IPX/SPX protocol
from the Adapter drop-down list.
■
Select Auto Detected from the Frame Type drop-down
list.
■
Select OK.
11
If TCP/IP is installed on your workstation, the TCP/IP
Configuration dialog box appears, requiring that you set other
protocol addresses and information. Refer to your Windows
NT user documentation for information about setting up your
TCP/IP configuration, and when you have entered the
necessary TCP/IP data, select OK. If you do not have TCP/IP
installed, these configuration screens will not appear.
12
Add additional clients (1 to 3) by following the above
procedures, or select Yes to save and initialize changes.
Type Set the Type to PCI when using the
Adaptec card. Default is ISA.
Number Select the bus number slot that the
card is plugged into. The total number
available depends on how your
hardware is configured.