Adaptec ANA-5930 Network Card User Manual


 
5-4
ANA-5910/5930/5940 User’s Guide
8
Select PCI from the Bus Type drop-down list in the Bus
Location dialog box, and select the bus number to which the
ATM adapter is attached from the Bus Number drop-down list.
Then select OK.
The installer copies the base driver to the following directory:
drive
:\
systemroot
\System32\drivers
where
9
When the Setup Message dialog box appears, insert Device
Driver for Windows NT Disk 2 in the diskette drive, and select
OK.
10
If NT SNMP has not been installed on your workstation, the
Setup Message dialog box appears advising you to install the
NT SNMP service and to configure the Adaptec ATM SNMP
agent. Select OK.
When the Network Settings dialog box appears, the ATMO
(base) Driver appears in the Installed Network Software list
box, and the Adaptec ATM adapter appears in the Installed
Adapter Cards list box.
11
Select Close to exit the Network Settings dialog box.
Autostart CIP Select the check box to automatically
start the CIP client driver at boot-up.
Back to Back PVC Select the check box to use the CIP
client in back-to-back mode without
involving the switch.
AARP server address Enter the address of the CIP ARP
server; 20-byte, 40 hex characters. If
the ARP server address has not been
established, use the default setting.
PVCs Use the PVCs list box to add, change
or remove PVCs.
drive = boot drive letter
systemroot = SystemRoot directory
Parameter Setting