Filter
Top Products
ADCP-80-526 • Issue 6 • December 2006
Page 4
© 2006, ADC Telecommunications, Inc.
• Rear protective input terminal covers and output terminal covers—Used to prevent
accidental contact with the power input and output terminals. The number of covers
provided depends on the fuse configuration.
• Designation card and card holder—Used to record information about the protected
equipment. The card holder has a pressure-sensitive adhesive backing to permit
attachment to the panel, the rack, or a location close to the panel. The designation card
inserts into the card holder. It is also available as an accessory item.
Figure 2. Packaged Hardware Components
REAR COVER FOR OUTPUT POWER TERMINAL BLOCKS,
ALARM TERMINALS, AND CHASSIS GROUND TERMINALS
#10 RING TERMINALS FOR
12-10 AWG WIRE (GROUNDING)
REAR COVERS FOR INPUT
POWER TERMINAL BLOCKS
DESIGNATION CARD,
PROTECTIVE COVER,
AND CARD HOLDER
MOUNTING BRACKETS
AND SCREWS FOR 19-INCH OR
23-INCH RACK INSTALLATION
3/8-INCH (9.525 MM) 12-24
SCREWS AND #12 WASHERS
5/16-INCH (7.936 MM) 8-32
FLAT-HEAD SCREWS
19-INCH
RACK MOUNTING
BRACKETS
18876-A
23-INCH
RACK MOUNTING
BRACKETS