ADTRAN 4200659L8 Switch User Manual


 
Chapter 3. Configuration
3-16 MX2800 STS-1 User Manual 61200659L1-1
Idle Timeout
After establishing a call and sending trap messages, the MX2800
STS-1 remains online for the amount of seconds entered in this
field. If the field is set to 0, the unit hangs up as soon as the trap is
sent.
Connection Timeout
The MX2800 STS-1 waits for a connection the amount of seconds
entered in this field. Timing begins as soon as the dial command is
issued. This field must be set for greater than 20 seconds.
Pause Between Calls
The MX2800 STS-1 waits between redial attempts the number of
seconds entered in this field.
Dialout On Trap
Enable or disable the MX2800 STS-1’s ability to dial out to report
traps.
M
ODEM
M
ODE
configured for
VT-100
reports error conditions
in plain ASCII with the following information:
The Unit ID value programmed in the
E
QUIPMENT
I
DENTIFICATION
portion of the
S
YSTEM
M
ANAGEMENT
screen (see System
Management on page 3-13)
A trap code indicating the error condition
A text description of the fault
The date and time when the error was logged
When
M
ODEM
M
ODE
is configured for
PPP
or
SLIP
, the MX2800
STS-1 logs into the PPP/SLIP host and reports the error conditions
to the hosts designated under
T
RAP
IP A
DDRESSES
(see Trap IP
Addresses on page 3-25).
Answer on Ring
Enable or disable the MX2800 STS-1’s ability to accept incoming
calls. If enabled, incoming calls are automatically answered by the
MX2800 STS-1, allowing you to remotely perform management
functions.