Filter
Top Products
Chapter 1 Hardware Configuration
15
1.7.2 Supplementary information about DIMMs
Your PCA-6359 Series can accept SDRAM memory chips (with or
without parity). Also note:
• SDRAM chips are usually thinner and have higher pin density than
EDO chips.
• Modules with 9 chips/side support ECC; modules with 8 chips/side do not
support ECC.
• Single-sided modules are typically 16, 32 or 64 MB; double-sided
modules are usually 32, 64, or 128 MB.
1.8 Memory Installation Procedures
To install DIMMs, first make sure the two handles of the DIMM
socket are in the "open" position. i.e. The handles lean outward.
Slowly slide the DIMM module along the plastic guides on both ends
of the socket. Then press the DIMM module right down into the
socket, until you hear a click. This is when the two handles have
automatically locked the memory module into the correct position of
the DIMM socket. To remove the memory module, just push both
handles outward, and the memory module will be ejected by the
mechanism in the socket.