Filter
Top Products
Chapter 2 Connecting Peripherals
23
To install the bracket, find an empty slot in your chassis. Unscrew the
plate that covers the end of the slot. Screw in the bracket in place of
the plate. Next, attach the flat-cable connector to CN4 on the CPU
card. Wire 1 of the cable is red or blue, and the other wires are gray.
Make sure that wire 1 corresponds to pin 1 of CN4. Pin 1 is on the
upper right side of CN4.
2.5 Ultra Wide SCSI Connector (CN5)
Note: Only the PCA-6359F model contains an Ultra Wide
SCSI connector.
The PCA-6359F has a 68-pin, dual inline connector for Ultra Wide
SCSI devices. Connection of SCSI devices requires special attention,
especially when determining the last drive on the SCSI chain. Refer to
Chapter 6 and your device's operating manual for detailed installation
advice.
2.6 USB Connector (CN6)
The PCA-6359 Series CPU card provides one USB (Universal Serial
Bus) interface, which give complete Plug & Play and hot
attach/detach for up to 127 external devices.The USB interface
complies with USB Specification Rev. 1.0, and is fuse-protected.
The USB interface is accessed through a 10-pin flat-cable connector,
CN6. The adapter cable has a 10-pin connector on one end and a USB
connector on the bracket.
The USB interface can be disabled in the system BIOS setup.