Advantech PCA-6359 Network Card User Manual


 
3.5 Chipset Features Setup .............................................................40
3.5.1 SDRAM (CAS Lat / RAS-to-CAS) ...................................40
3.5.2 DRAM Speculative Read................................................... 41
3.5.3 16 Bit I/O Recovery Time / 8 Bit I/O Recovery Time......41
3.5.4 Memory Hole At 15M-16M .............................................. 41
3.6 Power Management Setup .......................................................42
3.6.1 Power Management ........................................................... 42
3.6.2 PM Control by APM .......................................................... 42
3.6.3 Video Off Method.............................................................. 43
3.6.4 MODEM Use IRQ ............................................................. 43
3.6.5 HDD Power Down ............................................................. 43
3.6.6 ZZ Active in Suspend ........................................................ 43
3.6.7 PCI/VGA Act-Monitor ...................................................... 43
3.6.8 Soft-Off by PWR-BTTN ...................................................44
3.6.9 PowerOn by Ring............................................................... 44
3.6.10 PowerOn by Alarm ..........................................................44
3.7 PnP PCI Configuration Setup.................................................. 45
3.7.1 IRQ-xx assigned to : PCI/ISA PnP .................................... 45
3.7.2 DMA-x assigned to : PCI/ISA PnP ................................... 46
3.8 Load BIOS Defaults ..................................................................46
3.9 Load Setup Defaults .................................................................. 46
3.10 Integrated Peripherals .............................................................. 47
3.10.1 IDE HDD Block Mode .................................................... 47
3.10.2 IDE Primary Master/Slave PIO/UDMA Mode,
IDE Secondary Master/Slave PIO/UDMA Mode (Auto) 47
3.10.3 On-Chip PCI IDE Primary/Secondary ............................ 48
3.10.4 Onboard FDC Controller .................................................48
3.10.5 Onboard Serial Port 1 (3F8H/IRQ4) ............................... 48
3.10.6 Onboard Serial Port 2 (2F8H/IRQ3) ............................... 48
3.10.7 UART Mode Select .........................................................48
3.10.8 UART2 Duplex Mode ..................................................... 48
3.10.9 RxD, TxD Active ............................................................. 48
3.10.10 Onboard Parallel Port (378H/IRQ7).............................. 49
3.10.11 Parallel Port Mode (ECP + EPP) ................................... 49
3.10.12 ECP Mode Use DMA .................................................... 49
3.11 Password Setting .......................................................................49
3.12 IDE HDD Auto Detection ......................................................... 50
3.13 Save & Exit Setup .....................................................................50
3.14 Exit Without Saving .................................................................. 50