Filter
Top Products
112
PPC-150 User's Manual
Reset Configuration Data
When enabled, this feature allows the system to clear the last BIOS
configuration data and then reset the data with the default BIOS
configuration data.
The options are: Disabled (Default), Enabled.
PCI IRQ Activated By
If your IDE card is triggered by edge, set it at "Edge".
The options are: Level (Default), Edge.
PCI IDE 2nd Channel
This item allows you to designate an IDE controller board inserted into
one of the PCI slots as your secondary IDE controller.
The options are: Enabled (Default), Disabled.
PCI IDE IRQ Map To
This item allows you to configure your system to the type of IDE disk
controller that you are using. By default, Setup assumes that your
controller is a PCI device rather than an ISA controller. The more
apparent difference is the type of slot being used.
Your system is equipped with a PCI controller. Selecting PCI-AUTO
allows you to specify which slot has the controller and which PCI interrupt
(A, B, C or D) is associated with the connected hard drives.
The options are: PCI-AUTO (Default), ISA.
Primary IDE INT#
Remember that this setting refers to the hard disk drive itself, rather than
individual partitions.
Secondary IDE INT#
Since each IDE controller supports two separate hard drives, you can
select the INT# for each. You will note that the primary has a lower
interrupt than the secondary.
Selecting PCI-AUTO allows the system to automatically determine how
your IDE disk system is configured.