Filter
Top Products
150
PPC-150 User’s Manual
7. Unscrew the four screws on the power supply board. The power
supply board can be detached from the plastic housing after unplug-
ging the cables from the motherboard.
8. Remove the front panel by hand.
9. Unscrew the ten screws on the LCD holding plate to seperate the
plastic housing and LCD holding plate.The LCD inverter can also be
detached by unscrewing the three screws at the bottom (Toshiba LCD
only).
10. Detach the plastic housing.
11. Detach the LCD by unscrewing the four screws located on the each
corners.
12.The touchscreen is stuck on the LCD holding plate by a strongly
double-side adhensive tape. We do not recommend you to remove it
unless the touchscreen is defective and you would like to replace it.
Note: Because of the modular design of the LCD and touch-
screen, you do not disassemble the whole system step
by step if you would like to replace the defective LCD or
touchscreen. You just start disassembling the module
from the step 8. Then you can easily remove the LCD
and touchscreen by step 9 to step 12.