Agilent Technologies FS2100 Webcam User Manual


 
Introduction
The PCI Active Analysis Probe module provides a complete
interface between any PCI add-in slot and Agilent Logic
Analyzers. The Analysis Probe interface buffers and in state
mode latches and decodes all PCI cycle types and transactions.
The PCI Active Analysis Probe is a passive bus monitor which
does not assert any signals on the PCI bus. The PCI bus
signals are buffered and then terminated with 90k ohm/10pf
terminators so that they are impedance matched to the logic
analyzer. Since the PCI Active Analysis Probe does contains
high speed low skew buffers very little skew is introduced.
The configuration software on the diskette sets up the format
specification menu of the logic analyzer for compatibility with
your PCI bus. When the state configuration file is loaded, an
inverse assembler is also loaded which decodes PCI
transactions into easy to read mnemonics.
How to Use This
Manual
This manual is organized to help you quickly find the information
you need.
Analyzing the PCI Local Bus chapter introduces you to the
PCI Active Analysis Probe and lists the minimum equipment
required and accessories supplied for PCI bus analysis.
The State Analysis chapter explains how to configure the
PCI Active Analysis Probe to perform state analysis on your
PCI bus.
The Timing Analysis chapter explains how to configure the
PCI Active Analysis Probe to perform timing analysis on your
PCI bus.
The General Information chapter provides some general
information including the operating characteristics for the
PCI Active Analysis Probe module and the cable header
pinout.
7