Filter
Top Products
Specifications
126
Specifications
This appendix lists the specifications for the Agilent J3916A HSSI WanProbe.
Network Compatibility
Agilent J3916A
Base
Hardware: 10Base-T/100Base-TX RJ-45 and AUI, Telemetry Interface.
The probe can use either a Fast Ethernet network connection, an optional
Token-Ring network connection, or the SLIP link to communicate with a
management station.
Network Connection
The network connection is made using the standard AUI for 10 MB/s Ethernet.
10Base-T or 100Base-TX half-duplex connections are made using the standard
RJ-45 connector.
The HSSI WAN network connection is made using industry standard connectors.
You can use the optional Token-Ring telemetry interface to connect to the network
Media Station Access Unit interface (MsAU) by using the DB-9 connector and
STP (shielded twisted pair) cable, or by using the RJ-45 connector and UTP
(unshielded twisted pair) cable. The Token-Ring telemetry interface configuration
defaults to 16Mbps networks. Simultaneous network connections on both the
DB-9 and RJ-45 connectors will result in a fault condition without damage to the
Token-Ring interface.
Software Standards
Remote Network Monitoring Management Information Base (RFC 1757), SNMP
MIB-II (RFC 1213 and 2233), SNMP (RFC 1157), and Agilent probe private
MIBs.
Modem
Supports external Hayes-compatible modems from 300 to 38.4 K baud.