Filter
Top Products
12 U2751A User’s and Service Guide
1Getting Started
C. Install the Module Driver
1 Verify that your PC meets the minimum system
requirements as stated in “A. Check Your System” on
page 10.
2 Insert the Product Reference CD-ROM into your CD-ROM
drive.
3 The installer will automatically launch the Agilent Modular
Products Installation Menu. Click Hardware Driver to begin the
installation.
4 If the menu does not launch automatically, go to Start >
Run (on the Windows Start menu) and type <drive>:\
Driver\Hardware\setup_Hw.exe where <drive> is
your CD-ROM drive location. Click OK to begin the
installation.
5 Follow the instructions on the screen and click Next to
proceed.
NOTE
Please ensure that there are no instruments connected to the PC when
installing the driver.