Filter
Top Products
Albatron Anniversary Special Edition PX845PEV-800
33
Onboard FDC Controller
Select “Enabled” if your system has a floppy disk controller (FDC) installed on the system
board and you wish to use it. If you install an add-in FDC or the system has no floppy drive,
select “Disabled”. Options: Enabled (default), Disabled.
Onboard Serial Port 1
Select an address and corresponding interrupt for the first serial port. Options: Disabled,
3F8/IRQ4 (default), 2F8/IRQ3, 3E8/IRQ4, 2E8/IRQ3, Auto.
Onboard Serial Port 2
Select an address and corresponding interrupt for the second serial port.
Options: Disabled, 2F8/IRQ3 (default), 3F8/IRQ4, 3E8/IRQ4, 2E8/IRQ3, Auto.
UART Mode Select
This item allows you to select the Infra Red (IR) standard to be used. Options: Normal
(default), AS KIR, IrDA.
RxD, TxD Active
This item determines the RxD and TxD frequencies. Options: Hi / Lo (default), Hi / Hi, Lo / Hi,
Lo / Lo.
IR Transmission Delay
This item allows you to enable/disable IR transmission delay. Options: Enabled (default),
Disabled.
UR2 Duplex Mode
Select the transmission mode used by the IR interface. Full-duplex mode permits simultaneous
bi-directional transmission. Half-duplex mode permits transmission in only one direction at a
time. Options: Half (default), Full.
Use IR Pins
Consult your IR peripheral documentation to select the correct setting of the TxD and RxD
signals. Options: Full, Half (default).
Onboard Parallel Port
Select an address and corresponding interrupt for the onboard parallel port. Options: 378/IRQ7
(default), 278/IRQ5, 3BC/IRQ7, Disabled.
Parallel Port Mode
This option allows you to select an parallel port mode for the on board parallel port.
ECP (default) Extended Capabilities Port.
EPP Enhanced Parallel Port.
SPP Standard Printer Port.
ECP+EPP ECP & EPP mode.
Normal
EPP Mode Select
Select EPP port type 1.7 or 1.9. Options: EPP 1.9(default), EPP 1.7.
ECP Mode Use DMA
Select a DMA Channel for the parallel port during ECP mode. Options: 3 (default), 1.