Filter
Top Products
Albatron Anniversary Special Edition PX845PEV-800
35
When this option is enabled, each of the ranges are from 1 min. to 1 hr. except for HDD Power
Down, which ranges from 1 min. to 15 min. and includes a “disable” option.
Note: If you select Min. or Max. Power Saving modes, the “HDD Power Down” value and the
“Suspend Mode” value are both fixed.
Video Off Method
This option determines the manner in which the monitor goes blank.
Options:
V/H SYNC+Blank This selection will cause the system to turn off the vertical and
horizontal synchronization ports and write blanks to the video buffer.
Blank Screen (default) This option only writes blanks to the video buffer.
DPMS Support Initial display power management signaling.
Video Off In Suspend
This determines whether power to the monitor is switched off when the computer is in suspend
mode. Options: Yes, No (default).
Suspend Type
This item allows you to select the suspend type under the ACPI operating system.
Options: Stop Grant (default), PwrOn Suspend.
Modem Use IRQ
This determines the modem’s IRQ. Options: 3 (default), 4, 5, 7, 9, 10, 11, NA.
Suspend Mode
This item allows you to select the suspend time under the ACPI operating system. Options:
Disabled (default), 1Min, 2Min, 4Min, 6Min, 8Min, 10Min, 20Min, 30Min, 40Min, 1Hour.
HDD Power Down
When enabled, the hard disk drive will power down after a configurable period of system
inactivity. All other devices remain active. Options: Disabled (default), 1 Min, 2 Min, 3 Min, 4
Min, 5 Min, 6 Min, 7 Min, 8 Min, 9 Min, 10 Min, 11 Min, 12 Min, 13 Min, 14 Min,15Min.
Soft-Off by PWRBTN
Pressing the power button for more than 4 seconds forces the system to enter the Soft-Off state
when the system has “hung.” Options: Delay 4 Sec, Instant-Off (default).
Wake Up Control
If you highlight the “Wake Up Control” label and then press the enter key, it will display a
submenu with the following options:
PCI PME Wake Up
When you select “Enabled”, a PME signal from any PCI 2.2 card will awaken the system. And
if you want to awake from onboard LAN, you can also enable this item. Options: Disabled
(default), Enabled.
RTC Wake Up
When “Enabled”, you can set the date and time at which the RTC (real-time clock) alarm
awakens the system from Suspend mode. Options: Enabled, Disabled (default).