Filter
Top Products
www.aleratec.com
15
Using the USB Duplicator
Synchronous Copy+Compare - continued
4. Finish loading the blank target ash drives, then press the OK button
on the display panel.
5. The LCD will display the status of the copying process.
6. When Copy is complete LCD will display the following status:
If the Copy fails, the LCD will display the number of ash drives that
failed and passed.
7. When Copy is complete the Compare portion will automatically begin.
The LCD will display the status of the copying process.
8. When Compare is complete the display will show the total, and the
number that pass and fail.
Note: When Copy+Compare is in process the Green LED on the front
panel is blinking. Do not take out the drive while it is working. When
Copy+Compare is finished the Green LED stays on (no blinking). If an
error occurs during the process a Red LED will display.
ESC
OK
Copy 450M
15% 0:32 68M
ESC
OK
Compare 925M
15% 0:18 226M
ESC
OK
Total: 11/0
Pass 11 Fail 0
ESC
OK
ENT
ESC
ENT
ESC
ENT
ESC
ENT
ESC
Total OK: 5 OK: 5 NG: 0
1:03 OK: 5 NG: 0