Filter
Top Products
www.aleratec.com
21
Using the USB Duplicator
Main Menu
6.1 Format FAT
This function is used to format ash drives with the duplicator. If the
original format is FAT, then the format operation will not change the format,
but will write over any data on the ash drive.
If the format is not FAT (e.g. NTFS, Linux, or FAT multi-partition) the
controller will check the capacity of the ash drive. If the capacity is greater
than 2GB, it will automatically use FAT 32 format. If the capacity is less
than 2GB, it will use FAT 16.
1. Load the ash drives into the USB Duplicator. Use the UP or DOWN
arrow to scroll through the menu until Utility is displayed on the LCD
screen.
2. Use the UP and DOWN arrow keys to check the status of any of the
ash drives loaded in the machine. Drives inserted in the rst port
(source) will not be formatted.
ESC
OK
USB Duplicator
6. Utility
ESC
OK
Do FORMAT
Confirm?
ESC
OK
[Utility]
1. Format FAT