Filter
Top Products
www.aleratec.com
30
Using the USB Duplicator
7.4 Asyn Hold Time
This function allows you to set the time to exit Asynchronous Copying
when you pull all the USB ash drives out of the duplicator. The default
setting is 30 seconds. If after 30 seconds no new drives are plugged into
the USB Duplicator the LCD will ask to exit Asynchronous or to stay in
Asynchronous mode. Press OK to exit Asynchronous Copying or press
ESC to keep this status.
To change the default setting for Asyn Hold Time use the following
procedure:
1. Use the UP or DOWN arrow to scroll through the menu until Setup is
displayed on the LCD screen. Press the OK button to select.
2. Use the UP or Down arrow to scroll through the Setup options until
Asyn Hold Time is displayed on the LCD screen. Press OK.
3. Default setting is 30 seconds; press the arrow keys to change. Press
ESC to exit.
7.5 Ignore Size
To make sure the FAT table of each ash drive was copied correctly all
source and target ash drives should be the same capacity. Each ash drive
potentially has some capacity difference due to the manufacturing process.
To ensure both the source and target ash drives are at the same capacity
you can set the capacity tolerance. This function is used to set the tolerance
% of ash capacity difference between source and targets.
ESC
OK
USB Duplicator
7. Setup
ESC
OK
7. Setup:
4. Asyn Hold Time
ESC
OK
Asyn Hold Time
30sec.