Filter
Top Products
Chapter 2: Installation
30
Site
Requirements
The device should be placed on a table-top. Before installing the unit, verify that the
location chosen for installation meets the following site requirements.
General — Ensure that the power supply is correctly installed.
Power — The unit is installed within 1.5 m (5 feet) of a grounded,
easily accessible outlet 100-250V AC, 50-60Hz.
Clearance — There is adequate frontal clearance for operator access.
Allow clearance for cabling, power connections, and ventilation.
Cabling — The cabling is routed to avoid sources of electrical noise
such as radio transmitters, broadcast amplifiers, power lines, and
fluorescent lighting fixtures.
Ambient Requirements — The ambient unit operating temperature
range is 0 to 40ºC (32 to 104ºF) at a relative humidity of up to 95%,
non-condensing. Verify that water or moisture cannot enter the device
casing.
Unpacking This section contains information for unpacking the device, and includes the following
topics:
“Package Contents” on page 30
“Warranty” on page 30
“Unpacking Essentials” on page 30
Package Contents
While unpacking the device, ensure that the following items are included:
One AT- AT-8000/xx series unit
Rubber Feet for desktop installation
Rack-mount kit hardware accessories
An AC power cable
Stacking cable (Yellow color)
Console RS-232 cable with RJ-45 connector
Installation guide on CD
Warranty
The AT-AT-8000 series switches have a Lifetime Warranty (two years for Fan and PSU).
Go to www.alliedtelesis.com/warranty for the specific terms and conditions of the warranty
and for warranty registration.
Unpacking Essentials
Note
Before unpacking the device, inspect the package and report any evidence of
damage immediately.