Filter
Top Products
AT-FH812u and AT-FH824u User’s Guide
9
Changing the
Network
Configuration
Use the Network Configuration screen to configure the hub's Internet Protocol (IP)
parameters, set the bootup option, and define the maximum number of Telnet
sessions allowed. Table 3 defines the screen’s parameters listed in Figure 4.
------------------------------------------------------------------
System Configuration
Current Used New Setting
----------------------------------------------------
IP Address : 10.1.113.115 10.1.113.115
Subnet Mask : 255.255.0.0 255.255.0.0
Gateway IP : 0.0.0.0 0.0.0.0
SLIP IP : 0.0.0.0 0.0.0.0
Bootup IP : 0.0.0.0 0.0.0.0
MAX # of allowed Telnet sessions (0 - 2) : 2
<APPLY> <OK> <CANCEL>
The new IP address.
<Ctrl-F> forward a char, <Ctrl-B> backward a char.
-----------------------------------------------------------
Figure 4
System Configuration Example
Table 3
Network Configuration Parameters
Parameters Description
IP Address IP address of the agent you are managing. The Agent Module supports SNMP over UDP/IP transport
protocol. In this environment, all systems on the Internet, such as network interconnection devices
and any PC accessing the Agent Module, are assigned an IP address. Valid IP addresses consist of
four numbers, from 0 to 255, separated by periods. Anything outside of this format will not be
accepted by the configuration program. (The default address is 0.0.0.0.)
Subnet Mask Subnet mask of the agent you have selected. This mask identifies the host address bits used for
routing to specific submits. (The default subnet mask is 0.0.0.0.)
Default Gateway Gateway used to pass trap messages from the hub's agent to the management station. Note that the
gateway must be defined if the management station is located in a different IP segment. (The default
gateway is 0.0.0.0.)
SLIP IP IP address used to access the configuration program via an out-of-band SLIP connection to the serial
port on the Agent Module.
Bootup IP The default IP address assigned to this agent. This address is used only until you assign a new
address to the agent, or after downloading new firmware to the Agent Module.
Max # of
allowed
The maximum number of Telnet sessions allowed to simultaneously access the Agent Module.