Filter
Top Products
AT-FH812u and AT-FH824u User’s Guide
23
Changing System
Passwords
The User Passwords screen is used to display or modify user names and passwords
for the on-board configuration program. There are two user types: Administrator
and Guest. Only the Administrator has write access for parameters governing the
SNMP agent. You should, therefore, assign a user name and password to the
Administrator as soon as possible, and store it in a safe place.
Passwords can consist of up to 14 alphanumeric characters and are not case
sensitive. The configuration program will allow a user three attempts at entering a
password before locking the user out by terminating the connection. If for some
reason your password is lost, or you can not gain access to the System
Configuration Program, contact Allied Telesyn tech support for assistance. System
password parameters are defined in Table 15.
Configuring the
Out-of-Band
Console
The Console Configuration screen is used to configure the console connected to
the hub's serial port. The console parameters are described in Table 16.
Displaying
Statistics
The Statistics section on the Main Menu provides data on traffic passing through
the stack segments, hubs, ports, and each of the optional media modules. The
statistics these screens provide are described in the following sections.
Table 15
System Password Parameters
Parameters Description
Admin name: admin Administrator has access privilege of Read/Write for all
screens.
Password: null
Guest name: guest Guest has access privilege of Read Only for all screens.
Password: null
Table 16
Out-of-Band Console Parameters
Parameters Description
Lockout Status Enables/disables the lockout function.
Lockout Delay Time If no input is received from the attached device after this interval
(in minutes), the current session is closed.
Range: 0 - 99 minutes. Default is 10 minutes.
Auto-Refresh Period Specifies the interval at which statistics are read from the hub.
Options: 30, 60, 120, 180, 300 seconds. Default is 30 seconds.