Filter
Top Products
AT-FH812u and AT-FH824u User’s Guide
13
Hub
Configuration
Use the Hub Configuration screen to configure any hub in the stack. This menu is
used to configure the selected hub, as well as the Agent Module. Use the menu in
Figure 8 to view a basic description of all the hubs in the stack, including hardware
and firmware version numbers, or to open a more detailed configuration screen for
a specific hub. The information provided in Figure 8 is described in Table 7 and
Table 8, and in Figure 9:
Hub Selection
Menu
------------------------------------------------------------
Hub Configuration: Hub Selection Menu
Hub H/W EPROM FLASH PORT SNMP Switch Detailed
ID Version F/W Ver F/W Ver Number Agent Module Screen
---------------------------------------------------------------
1. 1 0.11 0.03 24 Master None <GO>
<PREV_PANEL>
Go to hub configuration detailed screen.
Use TAB or Cursor keys to move, <Enter> to confirm.
------------------------------------------------------------
Figure 8
Hub Selection Menu
Table 7
Hub Selection Parameters
Parameters Description
Hub ID Hub identifier in stack. (Up to 6 hubs may be connected via the
stack cable.)
H/W version Hardware version number of the repeater board.
EPROM F/W ver Version number of the repeater firmware in permanent
memory.
Flash F/W ver Version number of the repeater firmware in temporary memory.
Port Number Indicates whether this device has 12 or 24 repeater ports.
SNMP Agent Indicates whether an Agent Module is installed in this hub.
Switch Module Indicates whether an Internal Switch Module is installed in this
hub.