Filter
Top Products
AT-FH812u and AT-FH824u User’s Guide
19
Configuring Port
Security
Select Port Security Control from the Port Configuration screen to configure port
intrusion protection. The parameters are described in Figure 12 and Table 11.
-------------------------------------
Port Security Control (1 - 12)
Hub ID : 1
Port Mode Auth. Address L.S. Address Intrusion Action
1. MANUAL 0000e8-123456 0000e8-123456 WARNING & DISABLE
2. AUTO 0000e8-123798 0000e8-123798 WARNING & DISABLE
3. AUTO 0000e8-527456 0000e8-527456 INACTIVE
4. 000000-000000
5. 000000-000000
6. 000000-000000
7. 000000-000000
8. 000000-000000
9. 000000-000000
10. 000000-000000
11. 000000-000000
12. 000000-000000
<APPLY> <OK> <CANCEL> <PORT_13_24>
The authorized address assignment mode of the port.
Use TAB or Cursor keys to move. <Space> to select.
-------------------------------------
Figure 12
Port Security Control Parameters (from Port Configuration Screen)
Enabling a Port
. To enable a port that has been disabled by an intrusion:
(1.) Manually disable it in the Administration Status menu.
(2.) Re-enable it again.
These two steps will restore the connection. (See Note on
Configuring Port
Parameters
on page 16.)
Table 11
Definition of Port Security Control Parameters
Name Description
Mode AUTO - Copies authorized address from currently attached device.
MANUAL - Allows administrator to enter authorized address by hand.
Auth. Address MAC address of device authorized to access this port.
LS. Address MAC address of the last device attached to this port.
Intrusion Action Any of the following actions can be selected if intrusion is detected:
INACTIVE - Detection disabled.
WARNING AND DISABLE - Sends message to Trap Managers and
disables violated port.