Filter
Top Products
12 Patch Release Note
Patch 89262-08 for Software Release 2.6.2
C613-10402-00 REV H
transmitted while the IPsec SA renegotiation took place. This issue has been
resolved.
The IP Options fields were being processed multiple times if a Firewall or
NAT were enabled. This resulted in two Timestamps or Record_Route fields
being added at each hop, instead of one. This issue has been resolved.
All OSPF packets sent had an IP Precedence of 0 rather than 110. This issue
has been resolved.
A slow memory leak was observed in some circumstances when adding
and deleting routes in the routing table. This issue has been resolved.
If the remote PPPoE client was not responding to LCP Configure Requests,
the PPPoE access concentrator would continually send configure requests,
as the PPP template could not be configured to change this default setting.
This issue has been resolved.
The add ipv6 nd command did not work when the port parameter was
specified. This issue has been resolved.
When two devices (A and B) had an IPsec tunnel connecting them and the
default route of device A was to device B, device B had a fatal error. If A lost
a link, any packets for that link were delivered to B unencrypted. If these
packets were routed through device B to device A, then B recognised the
packets as needing to be decrypted and attempted it. This caused a fatal
error. This issue has been resolved.
Procedures for handling bgp update messages which contained an invalid
next_hop attribute specified in Section 6, RFC1711 were incorrect. This issue
has been resolved.
If the ENCO process used to encrypt an ISAKMP packet failed, a switch
reboot could occur. This issue has been resolved.
When a nested VLAN core port received a packet, it could trigger some
debug to the console port, and prevent further communication via that
console port. This issue has been resolved.
PCR: 40340 Module: IPG Level: 3
PCR: 40350 Module: OSPF Level: 2
PCR: 40372 Module: IPG Level: 2
PCR: 40378 Module: PPP Level: 2
PCR: 40399 Module: IPv6 Level: 3
PCR: 40402 Module: IPSEC Level: 2
PCR: 40403 Module: BGP Level: 2
PCR: 40405 Module: ENCO Level: 2
PCR: 40408 Module: SWMX,SWI Level: 2