Filter
Top Products
32 add ip filter Patch Release Note
Patch 89262-08 for Software Release 2.6.2
C613-10402-00 REV H
add ip filter
Syntax ADD IP FILter=filter-number {ACTion=INCLude|EXCLude}
SOurce=ipadd [SMask=ipadd] [ENTry=entry-number] [other-
parameters]
Description This command adds a pattern to a routing filter. For details about the
command parameters, see Table 12 on page 32.
Table 12: Parameters for the BGP route import feature in the add ip filter command.
Availability
Patches can be downloaded from the Software Updates area of the Allied
Telesyn web site at www.alliedtelesyn.co.nz/support/updates/patches.html
. A
licence or password is not required to use a patch.
Parameter Option/Range Description
filter-number
300...399
Filters in the range 300 to 399 are treated as routing filters, and use the action
parameter to specify the action to take with a route that matches the pattern.
ACTion The action to take when the filter pattern is matched.
INCLude Route information matching the filter will be included.
EXCLude Route information matching the filter will be excluded.
SOurce The source IP address, in dotted decimal notation, for the filter pattern.
SMask The mask, in dotted decimal notation, to apply to source addresses for this pattern.
The mask is used to determine the portion of the source IP address in the IP packet
that is significant for comparison with this pattern. The values of source and smask
must be compatible. For each bit in smask which is set to zero (0) the equivalent bit
in source must also be zero (0). If source is not 0.0.0.0, then smask can not be
0.0.0.0. The default is 255.255.255.255, unless source is 0.0.0.0.
ENTry entry-number The entry parameter specifies the entry number in the filter which this new pattern
occupy. Existing patterns with the same or higher entry numbers are pushed down
the filter. The default is to add the new pattern to the end of the filter.
*Caps denote command shortcuts