Filter
Top Products
26 add igmpsnooping routeraddress Patch Release Note
Patch 89262-08 for Software Release 2.6.2
C613-10402-00 REV H
■ RIP2 routers, 224.0.0.9
■ All PIM routers, 224.0.0.13
■ All CBT routers, 224.0.0.15
If IP is specified, addresses treated as router multicast addresses are specified
by the user using the ADD IGMPSNOOPING ROUTERADDRESS and the
DELETE IGMPSNOOPING ROUTERADDRESS commands. When in this
mode, the switch retains previous addresses that have already been specified.
If MULTICASTROUTER is specified, the following addresses are treated as
router multicast addresses:
■ DVMRP Routers, 224.0.0.4
■ All PIM routers, 224.0.0.13
If NONE is specified, the switch does not create router ports at all.
To add and delete reserved IP multicast addresses to and from the list of router
multicast addresses that are specified by the SET IGMPSNOOPING
ROUTERMODE command when the IP parameter is selected, use the
commands:
ADD IGMPSNOOPING ROUTERADDRESS
DELETE IGMPSNOOPING ROUTERADDRESS
The IP addresses specified must be from 224.0.0.1 to 224.0.0.255.
To display information about the current list of configured IP multicast router
addresses configured on the switch, use the command:
SHOW IGMPSNOOPING ROUTERADDRESS
add igmpsnooping routeraddress
Syntax ADD IGMPSNOOPING ROUTERADDRESS=ipaddr[,...]
Description where:
• ipaddr is a reserved IP multicast address in dotted decimal notation.
This command adds reserved IP multicast addresses to the list of router
multicast addresses. The IP address specified must be within the range
224.0.0.1 to 224.0.0.255. This command is only valid if the IGMP snooping
router mode is set to IP with the SET IGMPSNOOPING ROUTERMODE
command.