Filter
Top Products
20 Patch Release Note
Patch 89262-08 for Software Release 2.6.2
C613-10402-00 REV H
The next hop of an IPv6 RIPng Response message was not assigned with a
link local address when an invalid next hop was specified in the prefix field
of the route table entry. This issue has been resolved.
An error message was not returned if an unavailable interface was specified
for the enable test interface command. This issue has been resolved.
A dynamic VLAN created by GVRP should contain a tagged port, but it did
not. This issue has been resolved.
When an untagged port was added to a non-default VLAN, and then set as
tagged, it could not be added back to the default VLAN as an untagged
port. This issue has been resolved.
Hardware filtering has been enhanced so that the traffic class can be
remapped using classifiers and hardware filtering. This can increase the
chance of packets that match the classifier reaching the CPU because they
are transmitted to the CPU on a different queue and DMA channel. To
configure this type of filtering, use the command add switch hwfilter
action=setl2qos.
It was not possible to set a QoS policy to a port if the corresponding
classifier with IPv6 parameters was changed. This issue has been resolved.
If there were more than one port connected on the same IPv6 interface,
traffic stopped if a cable was unplugged from the egress port of the switch
and then plugged into a different port. This issue has been resolved.
STP restarted when GVRP sent a Join message for a newly created dynamic
VLAN. This issue has been resolved.
PCR: 40318 Module: IPV6 Level: 2
PCR: 40322 Module: TM Level: 3
PCR: 40334 Module: VLAN Level: 2
PCR: 40338 Module: VLAN Level: 2
PCR: 40341 Module: SWMX, SWI
PCR: 40342 Module: SWI Level: 2
PCR: 40343 Module: IPV6, VLAN Level: 2
PCR: 40348 Module: VLAN Level: 2