Filter
Top Products
Patch 89262-08 For AT-8900 Series Switches 9
Patch 89262-08 for Software Release 2.6.2
C613-10402-00 REV H
If the command enable switch accelerator function=icmpredirect had been
executed, there was no resulting entry in a script subsequently created by
the create config or show config dynamic commands. This issue has been
resolved.
If two protocol VLAN association rules were added to two different
VLANs, the second protocol association rule would not work. This issue has
been resolved.
When PIM or DVMRP was enabled, if IP multicast packets were received on
the non-RPF (Reverse-Path-Forwarding) interface, i.e. the wrong ingress
interface, the CPU could become highly utilised, and the packets were not
correctly Layer 2 switched. This issue has been resolved.
Adding, or deleting, port=42 to, or from, a VLAN could cause the entire
Layer 2 Multicast Table to be cleared. This would subsequently cause high
CPU utilisation under heavy multicast traffic. This issue has been resolved.
If VRRP had been enabled on the switch, then the routing of any packets
that entered the switch via a an interface on which VRRP was operating
would be performed in software, rather than using the L3 switching process
in the ASIC. This issue has been resolved.
If a timed-out ARP entry was renewed by BOOTP, the new entry be created
with no port association. This issue has been resolved.
Level 3
When an accelerator card is installed, and ports had been configured for
mirroring, the enable switch mirror caused an unnecessary warning
message to be displayed. This issue has been resolved.
When an accelerator card is installed, the set switch mirror command
caused the switch to display an incorrect message saying that the maximum
port number is 54. This issue has been resolved.
In certain scenarios when acting as a DHCP server, the switch would send
a DHCP ACK to an invalid MAC address. This issue has been resolved.
PCR: 40562 Module: SWNP Level: 2
PCR: 40565 Module: SWMX Level: 2
PCR: 40571 Module: SWMX Level: 2
PCR: 40574 Module: SWMX Level: 2
PCR: 40586 Module: SWMX Level: 2
PCR: 40592 Module: BOOTP Level: 2
PCR: 40471 Module: SWI Level: 3
PCR: 40474 Module: IPG Level: 3
PCR: 40493 Module: DHCP Level: 3