Filter
Top Products
24 enable ip igmp allgroup Patch Release Note
Patch 89262-08 for Software Release 2.6.2
C613-10402-00 REV H
Figure 1: Example output from the show ip igmp command.
Examples To show information about IGMP, use the command:
SHOW IP IGMP
See Also ENABLE IP IGMP ALLGROUP
DISABLE IP IGMP ALLGROUP
enable ip igmp allgroup
Syntax ENABLE IP IGMP ALLGROUP=[{port-list|ALL}]
where:
■ port-list is a port number, a range of port numbers (specified as n-m), or a
comma separated list of port numbers and/or ranges. Port numbers start
at 1 ad end at m, where m is the highest numbered Ethernet switch port,
including uplink ports.
Description This command enables the specified port(s) to behave as a multicast all-group
ports.
IGMP Protocol
--------------------------------------------------------------------------------
Status ........................... Enabled
Default Query Interval ........... 125 secs
Default Timeout Interval ......... 270 secs
Disabled All-groups ports ........ 1,5,7
Interface Name .......... vlan2 (DR)
IGMP Proxy .............. Off
Group List ..............
Group. 238.0.1.2 Last Adv. 172.50.2.1 Refresh time 34 secs
Ports 3,11,23
Group. 224.1.1.2 Last Adv. 172.50.2.1 Refresh time 130 secs
Ports 2,11,23
All Groups Last Adv. 172.50.1.1 Refresh time 45 secs
Ports 1#,11,23
Interface Name .......... vlan4 (DR)
IGMP Proxy .............. Off
Group List ..............
No group memberships.
--------------------------------------------------------------------------------
Table 9: New parameter in the output of the show ip igmp command.
Parameter Meaning
Disabled All-groups ports A list of ports that are prevented from behaving as IGMP all-
group ports.