Filter
Top Products
Using The System Setup Screen
2-3
Using The System Setup Screen
Use the System Setup screen to enter settings that are mode-independent.
Figure 6. The System Setup Screen
The following table describes the fields in the System Setup screen.
Admin
This is used to identify the computer. Provide this information if this computer is
normally used.
If the computer has both a 10/100BaseT Ethernet port, and a Wireless interface, then it
will have a different MAC address for each. The MAC address is also called the
“Physical Address”. This address is obtained by checking the Properties for the desired
interface, but the provided Set to my PC buttons make this unnecessary.
Ethernet Port - the MAC address, on the computer, for the 10/100BaseT Ethernet port.
Wireless Interface - the MAC address, on the computer, for the Wireless interface.
Set to my PC - only one of these buttons will work. If connected via Wireless, the
button for the Wireless interface will insert the computer’s Wireless MAC address into
the field provided. If connected via the Wired Ethernet interface, the button for the
Ethernet port will insert the computer’s Ethernet MAC address into the field provided.
If enabled, and the MAC address of the computer is provided, users are not prompted
for the password when they connect using the computer.
Users should set a password for the admin login, using the password fields below. This
option is provided to allow users to set a password, but avoid the inconvenience of being
prompted for the password whenever they want to change the settings.
This login is required to change any settings on the APC 3-in-1 Wireless Mobile Router.
(By default, the password is APC, so the first time a connection is made, there is no
prompt for the password.)
Check this box to change the current password, and then enter the required password in
the fields below. If this checkbox is enabled, and the password fields left blank, then the
password is cleared (set to no password).
Enter the new password here.
Note that if the password is set, a prompt appears for the username and password when
a connection is made. Use Admin as the user name.
Re-enter the new password in this field to ensure it is correct.
Administrator PC Mac Address
No login required for admin PC
Change Admin login
New Password
Verify Password