Filter
Top Products
®
®®
®
ADDENDUM
NetworkAIR ACPA4000
18
To use Secure CoPy (SCP) to upgrade the firmware for one Network
Management Card:
1. Identify and locate the firmware modules described in the preceding
instructions for FTP.
2. Use an SCP command line to transfer the AOS firmware module to the
Network Management Card. The following example assumes a
Network Management Card IP address of 158.205.6.185, and an AOS
module of apc_hw02_aos_225.bin.)
scp apc_hw02_aos_225.bin apc@158.205.6.185:apc_hw02_aos_225.bin
3. Use a similar SCP command line, with the name of the application
You cannot upgrade the AOS firmware module of any APC
device directly from firmware version 1.x.x to 2.1.0 or later.
The upgrade attempt will fail.
To upgrade the AOS firmware module of an APC device from
version 1.x.x to 2.1.0, use the firmware upgrade tool, a self-
extracting executable file available on the NetworkAIR PA
Utility CD or available at no cost from the support section of
the APC web site (www.apc.com/support).
Each upgrade tool is specific to an APC product type. Do not
use the tool from one product CD to upgrade firmware of a
different APC product. If you use a version of the tool from the
APC Web site, make sure that you use the upgrade tool that
corresponds with your APC product type.
If your APC device is running version 2.0.1 or later of the AOS
firmware module already, you may upgrade directly to a later
2.x.x version 2.1.0 or a later version.