Filter
Top Products
®
®®
®
ADDENDUM
NetworkAIR ACPA4000
6
Pre-configuring the Network Management Card
To pre-configure the Network Management Card:
1. Use the link in the Start menu to launch the Wizard application, and
then click Next > on the opening screen.
2. Select the Custom (Advanced) option from the “Installation Options”
screen, and then click Next >.
3. Select the Define a New Configuration File (Typical) option from the
“Custom Installation” screen, and then click Next >.
4. Configure your network settings. At a minimum, you must configure the
TCP/IP settings (System IP, Subnet Mask, and Default Gateway
addresses). As long as the Network Management Card’s TCP/IP
settings are configured before deployment, the Network Management
Card can be reconfigured remotely at a later time.
5. Click Next > as many times as needed to cycle through the Network
Management Card’s settings. Bypass any setting that you do not want
to configure.
6. Stop at the “Customize the settings that will be transmitted to the
Management Card” screen. Choose to transmit the TCP/IP settings
(System IP, Subnet Mask, Default Gateway addresses, and BOOTP)
and any additional options you want to configure, then click Next >.
7. Verify the selections you have made on the “Configuration Summary”
screen. You can save or print the settings. If you save the settings, you
can load them into the Wizard at a later time. Click Next >.
8. Select the Locally (via serial port) option from the “Transmit Current
Settings” screen, and then click Next >.
If you intend to use the Wizard to reconfigure Network
Management Cards, do not disable FTP Server Access.