Filter
Top Products
Basics - 4
Troubleshooting and Repair Tips
The monitor stand does not need to be removed before the
rear housing is removed.
When the video and main deflection boards are removed from
the bezel, special care must be taken to avoid damaging the
user brightness and contrast controls. These knobs protrude
about one inch past the main bracket and will not support the
weight of the main deflection board and attached brackets.
The video board and the main deflection board cannot be
separated without risk of damaging the CRT connector.
Therefore, the video board and main deflection board are
considered one module and will be replaced accordingly.
Connectors P302, P702, and P703 on the main deflection
board and video board are difficult to remove. Use a small,
flat-blade screwdriver to gently pry back the tabs before
removing these connectors.