Open as PDF
Take Apart Bezel - 39
Carefully line up the brightness and
contrast controls into the bezel when installing. The controls
will bind on the bezel tabs and not operate if not carefully
Position a sturdy nonabrasive object
inside the bezel. Carefully place the CRT and video and main
deflection board assembly on the sturdy object. Lift the bezel
and line up the screw holes and brightness and contrast
knobs with the CRT and video and deflection board assembly.
Slide the monitor until the lower edge of the bezel is
supported by the object. This will hold the bezel in place
while the screws are installed.