Filter
Top Products
24
Using the Projector
Scribble
The
scribble
button activates on-screen annotation.
1
Press the
scribble
button. The cursor changes to a pencil.
2
Press the right disk mouse button (Figure 20 on page 25) to
display the color selector. Use the disk mouse to position the
cursor on the desired color, then press the left mouse button.
Press the right button again to close the color selector.
3
Use the disk mouse to move the pencil to where you want to
start the annotation.
4
Press the left mouse button. The cursor changes to an upright
pencil.
5
Use the disk mouse to draw your annotation. Press the left
mouse button to complete the annotation.
6
To exit Scribble, press the
scribble
button. The annotation is
automatically deleted (it cannot be saved).
Power
The Power button turns the projector on and off, and functions
the same on the keypad and remote. When you press power
while the projector is on, the lamp stays on for 15 seconds before
shutting off. If you press power again within 15 seconds, the pro-
jector returns to normal operation immediately. If you don’t press
power again, the lamp turns off after 15 seconds. The fan contin-
ues to run until the projector has cooled (approximately 30 sec-
onds).
NOTE: For model 9000-INT: To
use video input, an optional video
board must be installed in the
projector. Contact Boxlight for
more information.
Video 1 and 2
When you have more than one source (computer or video) con-
nected to the projector, select between them by pressing the but-
ton for the source you want.
Press
video 1
or
2
to display the image from your video player.