Filter
Top Products
4. Drag the MPKG file to the Packages box in the dialog box.
5. Click Install.
The software installs on the selected computers.
g To deploy SMART software using Terminal
1. In the Finder, browse to /Applications/Utilities, and then double-click Terminal.
The Terminal window appears.
2. Type the following command:
sudo installer -target / -pkg "[Path]/[File name].mpkg"
Where
o
[Path] is the path to the MPKG file.
o
[File name] is the name of the MPKG file.
N N OTE
This command installs only SMARTNotebook software, SMARTProductDrivers and
SMARTResponse software if you haven’t customized the MPKG file using
SMARTInstallManager.
3. Press RETURN.
4. Type your administrator password, and then press RETURN.
Activating the software after installation
There are two situations in which the software doesn’t activate completely:
l Imaging a computer: Forthe software to activate properly, each computer you install it on
must have a unique installation ID. If you use a computer image or clone a hard drive to set up
multiple computers, they all have the same installation ID as the original computer, which can
cause an activation error.
l Protecting software for computer configurations: If you use system recovery or protection
software, you should activate the software before you lock or freeze the computerfor your
users. However, if you can’t, you must activate the software afterward.
Run the activation wizard while connected to the network or complete the following procedure to
activate the software on each computer.
C HA PT ER 3
Deployingthesoftware
12