Filter
Top Products
Chapter 2: Hardware setupChapter 2: Hardware setup
Chapter 2: Hardware setupChapter 2: Hardware setup
Chapter 2: Hardware setup
2-182-18
2-182-18
2-18
To install an optical drive:
1. From the front panel, insert the
rear end of the optical drive into
the 5.25-inch drive bay.
2. Place the metal bracket parallel to the side of the optical drive,
matching its two pegs with the lower holes, and the bracket holes
with the standoffs on the base of the chassis.
3. Secure the bracket with two
screws.
The metal bracket should fit completely to ensure that the optical drive
is securely in place.
Drive holes to match theDrive holes to match the
Drive holes to match theDrive holes to match the
Drive holes to match the
pegs on the metal bracketpegs on the metal bracket
pegs on the metal bracketpegs on the metal bracket
pegs on the metal bracket
Standoffs to match theStandoffs to match the
Standoffs to match theStandoffs to match the
Standoffs to match the
holes on the metal bracketholes on the metal bracket
holes on the metal bracketholes on the metal bracket
holes on the metal bracket
Holes to match the standoffsHoles to match the standoffs
Holes to match the standoffsHoles to match the standoffs
Holes to match the standoffs
Bracket pegsBracket pegs
Bracket pegsBracket pegs
Bracket pegs
Drive metal bracketDrive metal bracket
Drive metal bracketDrive metal bracket
Drive metal bracket