Filter
Top Products
ASUS MAXIMUS VI IMPACT
3-19
Chapter 3
DRAM Voltage Frequency [Auto]
Allows you to adjust the DRAM switching frequency. Assign a xed high DRAM
frequency to increase the overclocking range or a low DRAM frequency for a better
system stability.
Conguration options: [Auto] [Manual]
The following item appears only when you set set the DRAM Frequency Mode item to
[Manual].
DRAM Fixed Frequency(KHz) [300]
Allows you to set a xed DRAM frequency. Use the <+> or <-> keys to
adjust the value. The values range from 300kHz to 500kHz with a 10kHz
interval.
Tweakers’ Paradise
The subitems in this menu allow you to set the CPU ratio and features.
BCLK Tuning
VCCIN Shadow Voltage [Auto]
Allows you to set a pseudo voltage for VCCIN. Use the <+> or <-> key to adjust the
value. The values range from 0.800V to 2.440V at 0.010V increment.
Termination Anti-Aliasing [Auto]
Set this item to [Enabled] to smooth out the change of the PLL Termination Voltage,
which helps yield a better overclocking result.
Conguration options: [Auto] [Disabled] [Enabled]
Initial PLL Termination Voltage [Auto]
Initial Voltage at which CPU BCLKs are terminated. Maintaining a level close to CPU
Input Voltage helps base clock overclocking. Use the <+> or <-> key to adjust the
value. The values range from 0.00V to 3.00V at 0.00625V increment.
PLL Termination Reset Voltage [Auto]
Set a phase-locked loop termination reset voltage. Use the <+> or <-> key to adjust the
value. The values range from 0.00V to 3.00V at 0.00625V increment.
Eventual PLL Termination Voltage [Auto]
Set an eventual phase-locked loop termination voltage. Use the <+> or <-> key to
adjust the value. The values range from 0.00V to 3.00V at 0.00625V increment.