2-26 Chapter 2: Hardware information
4. Hard disk activity LED connector (4-pin HDLED1)
This connector supplies power to the hard disk activity LED. The read
or write activities of any device connected to the SCSI connectors or
the SATA connectors cause this LED to light up.
5. USB connector (10-1 pin USB34)
This connector is for USB 2.0 ports. Connect the USB module cable to
this connector, then install the module to a slot opening at the back
of the system chassis. This USB connector complies with USB 2.0
specification that supports up to 480 Mbps connection speed.
The USB port module is purchased separately.
P5MT-S
®
P5MT-S SCSI/SA
TA Card Activity LED Connector
HDLED1
1
ADD_IN_CARD_ACT#
NC
ADD_IN_CARD_ACT#
NC
P5MT-S
®
USB+5V
USB_P3-
USB_P3+
GND
NC
P5MT-S USB 2.0 Connector
USB34
USB+5V
USB_P2-
USB_P2+
GND