Filter
Top Products
Chapter 12 Avaya P330 Layer 3 Features
104 Avaya P332GT-ML User’s Guide
The DHCP/BOOTP server uses the relayed network information to decide from
which subnet the address should be allocated. Therefore, the DHCP/BOOTP server
must be configured to allocate addresses from the relayed networks configured on
the P330.
DHCP/BOOTP Relay in P330 is configurable per VLAN and allows you to specify
two DHCP/BOOTP servers. In this case, it duplicates each request, and sends it to
both servers. This provides redundancy and prevents the failure of a single server
from blocking hosts from loading.
You can enable or disable or DHCP/BOOTP Relay in P330.
BOOTP/DHCP CLI Commands
In order to... Use the following command...
Enable or disable relaying of bootp
and dhcp requests to the BOOTP/
DHCP server
[no] ip bootp-dhcp relay (no -
restores default)
Add or remove a BOOTP/DHCP
server to handle BOOTP/DHCP
requests received by this interface
[no] ip bootp-dhcp server (no -
restores default)
Select the networks from which the
bootp/dhcp server shall allocate an
address
[no] ip bootp-dhcp network (no -
restores default)