Filter
Top Products
24 AutoView 424 Installer/User Guide
9. Highlight Save Changes and press Enter.
-or-
Press Escape to exit this operation without adding the channel.
To edit an existing channel:
1. Highlight the channel you wish to change in the Administrator Channel List.
2. Press the Control key twice to access the Command menu.
-or-
Press the F2 key once. (If you press F2, skip to step 4.)
3. Select Edit Channel from the Command menu.
4. Enter the new channel name, address, ID dwell time and Scan dwell time.
Press Enter to accept.
5. Highlight ID Setup and press Enter. Use the Arrow keys to position the ID
window where you would like it to appear when this channel is selected.
Press Enter. For more information, see Configuring the ID window later
in this chapter.
6. Select Save Changes and press Enter.
To delete an existing channel:
1. Highlight the channel you wish to delete in the Administrator Channel List.
2. Press the Control key twice to access the Command menu.
-or-
Press the Delete key. (If you press Delete, skip to step 4.)
3. Highlight Delete Channel.
4. Type Y or N at the prompt to confirm the deletion and press Enter.
Configuring the ID window
The ID window appears when you change channels and displays the name
of the selected channel. This window can be individually configured for each
channel in your system. The characteristics of the ID window can be changed
from the Edit Channel menu. This option is only available if you are operating
in non-secure mode or if you are the system administrator.