Filter
Top Products
64 CCM840/1640 Installer/User Guide
Server PPP Command Parameters
Parameter Description
DISABLE Disables the PPP server.
ENABLE Enables the PPP server.
LOCALIP=<local_ip> IP address to be used to connect the CCM over the PPP
connection. Must be on same subnet as REMOTEIP address.
REMOTEIP=<rem_ip> IP address to assign to the PPP client end of the PPP connection.
Must be on same subnet as LOCALIP address.
MASK=<subnet> LAN subnet for the PPP dial-in client.
Examples
The following command enables the PPP server with a local IP address of
192.168.0.1, a remote IP address of 192.168.0.2 and a subnet mask of 255.255.255.0.
> ser ppp ena loc=192.168.0.1 rem=192.168.0.2 mas=255.255.255.0
The following command enables the PPP server with previously-configured IP
and subnet mask values. This form of the command would not be valid unless
the IP and subnet mask values had been previously configured.
> server ppp enable
Server RADIUS command
The Server RADIUS command defines or deletes RADIUS parameters for the
CCM RADIUS client. For more information, see RADIUS authentication in
Chapter 3.
When you enter this command, you are prompted to confirm or cancel the
specified changes.
Access right: SCON
Access level: APPLIANCEADMIN
Syntax
SERVER RADIUS PRIMARY|SECONDARY
IP=<radius_ip> SECRET=<secret> USER-RIGHTS=<attr>
[AUTHPORT=<udp>] [TIMEOUT=<time-out>] [RETRIES=<retry>]
- or -
SERVER RADIUS PRIMARY|SECONDARY DELETE